ISO 11952:2019
2019-05
ISO 11952:2019
Résumé
This document specifies methods for characterizing and calibrating the scan axes of scanning-probe microscopes (SPMs) for measuring geometric quantities at the highest level. It is applicable to those providing further calibrations and is not intended for general industry use, where a lower level of calibration might be required.
This document has the following objectives:
— to increase the comparability of measurements of geometrical quantities made using SPMs by traceability to the unit of length;
— to define the minimum requirements for the calibration process and the conditions of acceptance;
— to ascertain the instrument's ability to be calibrated (assignment of a "calibrate-ability" category to the instrument);
— to define the scope of the calibration (conditions of measurement and environments, ranges of measurement, temporal stability, transferability);
— to provide a model, in accordance with ISO/IEC Guide 98-3, to calculate the uncertainty for simple geometrical quantities in measurements using an SPM;
— to define the requirements for reporting results.
Informations générales
-
État actuel: PubliéeDate de publication: 2019-05Stade: Norme internationale confirmée [90.93]
-
Edition: 2
-
Comité technique :ISO/TC 201/SC 9ICS :71.040.40
- RSS mises à jour
Cycle de vie
-
Précédemment
AnnuléeISO 11952:2014
-
Actuellement
